[Lowfer] What is a better way to cut Lexan???

Sun, 10 Nov 2002 22:31:46 -0500

I forgot, a hacksaw will work as long as the blade pitch is around 18-20
teeth.

Denis

----- Original Message -----
From: "Denis Cote" <[email protected]>
To: <[email protected]>
Sent: Sunday, November 10, 2002 10:28 PM
Subject: Re: [Lowfer] What is a better way to cut Lexan???

> A jigsaw, rotozip or tablesaw. Just make sure the blade is nice and sharp!
>
> Good luck,
> Denis W1WV
>
> ----- Original Message -----
> From: "WE0H" <[email protected]>
> To: <[email protected]>
> Sent: Sunday, November 10, 2002 10:20 PM
> Subject: [Lowfer] What is a better way to cut Lexan???
>
>
> > I am cutting some 3/8th inch thick Lexan sheet for a LF project and need
a
> > better way to cut it rather than a crosscut handsaw.
> > Thanks,
> > Mike>WE0H
> > http://www.we0h.us/lf.html
> >
> >
> > _______________________________________________
> > From the Lowfer mailing list
> > Send messages to: [email protected]
> > To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer
> >
>
>
> _______________________________________________
> From the Lowfer mailing list
> Send messages to: [email protected]
> To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer