[Lowfer] Let the 185.3 party begin: Recalibration of -20db

Jay Rusgrove [email protected]
Sat, 26 Jan 2002 06:26:58 -0500


Bill

Just got this e mail from Wednesday...

I was curious about that. Sounds like I wasn't that far off. I'm trying to find
other methods for more accurate signal level readout. I'll let you know what I
find.

Jay Rusgrove, W1VD

"Ashlock,William" wrote:

> Jay,
>
> Your 17.8db measurement of my signal differential was very close to actual.
> Very impressed!
>
> I have a chart required that reads out the input current to the loop
> final(s) and I can change the gain in steps of 10. All I have to do is
> increase the gain 10X when the lower power WA code is running and set the
> Vcc controller to  make the  two pen positions exactly the same. Turns out
> that I was just under 25% stronger on the weaker signal than I should have
> been.
>
> Anyone seeing the Rat Pack tonight?
>
> Bill
>
> *********************************************************************
> This footnote confirms that this e-mail message has been scanned for
> the presence of known computer viruses by the MessageLabs Virus
> Control Centre. However, it is still recommended that you use
> local virus scanning software to monitor for the presence of viruses.
> *********************************************************************
>
> _______________________________________________
> Lowfer mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/lowfer