[Lowfer] Operating from 12VDC battery full time.
Les Rayburn
[email protected]
Sat, 23 Feb 2002 23:38:54 -0600
Tonight I was testing my new set up for emergency operation preparing for
an upcoming
MARS net. I've just purchased a large, deep cycle marine battery for
powering the
shack. Made up some cables with quick disconnect fuses, etc.
When I switched from the power supply to the battery the noise floor on 518khz
the noise floor dropped quite a bit! Tuning around a bit, I was really
surprised, considering
that I use a very large, (non-switching) type power supply, with lots of
filtering...the
AC is filter and conditioned, etc. But there was the proof, a much quieter
receiver.
Now my mind is racing at the possibilities for improved weak signal
reception. I have
also purchased a plastic marine box and automatic charger, which I had planned
to install just outside the shack window so that the battery could be kept in
a fully charged condition.
My question now is, is it possible to operate the station from the battery
full time,
with the charger connected and protected, perhaps by diodes or something?
Have others tried this!!!??
73,
Les Rayburn, N1LF
Les Rayburn, director
High Noon Film & Interactive
100 Centerview Drive
Suite 111
Birmingham, AL 35216
(205) 824-8930
(205) 824-8960 FAX
(205) 253-4867 CELL
http://www.highnoonfilm.com