[Lowfer] NC Jason signal copied in MN

[Denis Cote]

Lyle et al,

Which mode setting are you using with Jason software? I am confused as the
800Hz offset. I've been using CW with the narrowest filter setting and no
luck copying. I notice under the options menu there are settings for RX USB
and RX LSB. Do you set your receiver to USB or LSB to instead of CW? Or do
you put the rig on CW, dial the frequency and leave it there?

Regards,

Denis
W1WV
Swansea, MA

----- Original Message -----
From: "Lyle Koehler" <lyle@mlecmn.net>
To: <lowfer@mailman.qth.net>
Sent: Friday, February 01, 2002 10:06 PM
Subject: [Lowfer] NC Jason signal copied in MN


> Conditions are pretty good this evening. I finally got recognizable copy
of
> NC's Jason message earlier this evening. After unplugging a known noise
> source (power supply for a notebook computer that I was setting up with a
> logging program), I've gotten perfect copy for the past 20 minutes.
> Congratulations again to Dex!
>
> Lyle, K0LR
>
> _______________________________________________
> Lowfer mailing list
> Lowfer@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/lowfer