[Lowfer] ARGO Cal.

[Peter Barick]

Re: ARGO Use And Rx Calibration

I'm unfamiliar with ARGO but have collected past emails on ARGO topics.
These and the installation guide are of help, but one point is still
unclear and concerns "rx calibration." It's been mentioned only on this
list and references a 60kHz signal for calibration. Out of my bandwidth,
as my rx is a Drake R8 and coverage starts at 100kHz. So what to do?

Can I use WWV at, say, 5.0mHz and would I then use ARGO to check for
... what?

I see that ARGO's Setup has an offset factor, how do I determine if it
is needed? and how much? and for which rx mode, ie, usb, lsb, cw?

Thanks in advance,
Peter