[LOGic] Logic 8 message

[Joe Dubeck]

Julio-

This probably won't help, but to steer you in the right direction, here's my story:

I'm using LOGic 9.0, but even before with 8.0, I never get the error message connected to my ICOM 7800.

I did get a timeout message when I had configured LOGic to also connect to a second radio (Kenwood TS-2000) and that radio was turned off so LOGic couldn't find it. Even then, I got the error message just once when LOGic started and even then, LOGic still opened fine--except the radio information wasn't there.

I'm using Win-8.1 but the above was true even back to Win-XP. My radio interface went directly from LOGic through a micro KEYER 2R+ but now is first going through TRX-Manager.

It seems that a lot of us hams spend more time trying to get our computerized ham radio software and systems working than we do actually communicating on the air. Hi!

Good luck . . .

-Joe, NA9A


-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net] On Behalf Of Julio Peralta
Sent: Sunday, March 23, 2014 7:10 AM
To: logic at mailman.qth.net
Subject: Re: [LOGic] Logic 8 message

Happens to me all the time with my ICOM 7800. Don't know what the fix is.

Julio, W4HY

-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net] On Behalf Of k1vc at cox.net
Sent: Saturday, March 22, 2014 10:10 PM
To: LOGic at mailman.qth.net
Subject: [LOGic] Logic 8 message

Hello All,

I run LOGic 8.0.104 with a Yaesu FT-1000D and FIF-232C CAT System.  From the time I open LOGic until I close out of it, I get the following message:

Yaesu FT-1000 (com1)
A timeout occurred while attempting to communicate with a rig.
Make sure a rig is turned on and check cabling and setup parameters.

POLLING DISABLED. 0 characters in buffer.

In order to have the radio communicate with LOGic, I have to go to TOOLS > Reset radio and Rotor Interface.

I can be sitting in front of the radio just listening and the message will pop up and I lose communication with the radio and LOGic.

My parameters are:

Radio 1: FT 1000 (6.0 or later ROM)
Port:  com1
Baud rate:  Ø  (should this be 4800?)
Stop Bits:  2
DTR and RTS both are checked.
Polling interval in seconds (polled rigs only):  2.0

Anyone experience the same problem?

Thanks,
Vin, 73
K1VC
______________________________________________________________
LOGic mailing list
Home: http://mailman.qth.net/mailman/listinfo/logic
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:LOGic at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
LOGic mailing list
Home: http://mailman.qth.net/mailman/listinfo/logic
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:LOGic at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html