[LOGic] Logic 8 message

[Rick Tarbert]

Make sure your comm port baud rate is set the same as logic, if you 
hadn't already done so.
Rick AK3E

On 3/22/2014 10:37 PM, k1vc at cox.net wrote:
> I changed my Baud rate from Ø to 4800, (just to try it out) and this time, I received the following message:
>
> Yaesu FT-1000 (com1)
> A timeout occurred while attempting to communicate with a rig.
> make sure rig is turned on and check cabling and setup parameters.
>
> (get_cur() flags) 0 characters in buffer.
>
> Very frustrating.
>
> Vin, 73
> K1VC
>
> ---- k1vc at cox.net wrote:
>> Hello All,
>
> I run LOGic 8.0.104 with a Yaesu FT-1000D and FIF-232C CAT System.  From the time I open LOGic until I close out of it, I get the following message:
>
> Yaesu FT-1000 (com1)
> A timeout occurred while attempting to communicate with a rig.
> Make sure a rig is turned on and check cabling and setup parameters.
>
> POLLING DISABLED. 0 characters in buffer.
>
> In order to have the radio communicate with LOGic, I have to go to TOOLS > Reset radio and Rotor Interface.
>
> I can be sitting in front of the radio just listening and the message will pop up and I lose communication with the radio and LOGic.
>
> My parameters are:
>
> Radio 1: FT 1000 (6.0 or later ROM)
> Port:  com1
> Baud rate:  Ø  (should this be 4800?)
> Stop Bits:  2
> DTR and RTS both are checked.
> Polling interval in seconds (polled rigs only):  2.0
>
> Anyone experience the same problem?
>
> Thanks,
> Vin, 73
> K1VC
> ______________________________________________________________
> LOGic mailing list
> Home: http://mailman.qth.net/mailman/listinfo/logic
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:LOGic at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> LOGic mailing list
> Home: http://mailman.qth.net/mailman/listinfo/logic
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:LOGic at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>