[LOGic] NEW LOGIC ERROR? LOSS OF CAT

[Dennis Hevener]

This is definitely a LOGic error.

Check the description entered for the rig in setup--It may be too long.  
Try deleting or renaming radio.ini and setting up the rig again.

Tnx & 73,

Dennis

On 9/18/2012 1:50 PM, K0DAN wrote:
> This is a question for LOGic users who are using a combination of Flex PSDR,
> LOGic, and DDUTIL.
>
> I am running DDUTIL 2.1.0.04, PSDR 2.3.5, and LOGic 8 on a WIN7 PC. I have
> been running these for several years with no changes (except for occasional
> DDUTIL & PSDR updates).
>
> About a week or two ago I discovered that my LOGic is no longer responding
> to CAT commands. Typical reboot, clean, and restart procedures do not change
> anything.
>
> When LOGic starts (and tries to communicate via the serial ports) I get the
> following error:
>
> ERROR 1881 "Error with label 1 - Caption: String is too long to fit" has
> occurred in the program FORM1.INIT, Line 4.
>
> If I ignore the error and continue, the software will start but will not
> report rig activity and when I try to reset the CAT interface I get the
> following/similar error:
>
> "Error with label 1 - Caption: String is too long to fit"
>
> Have others seen this issue? I am trying to find out if it is being caused
> by LOGic or DDUTIL, and looking for ideas what might be causing this error
> or how I can further troubleshoot?
>
> Thanks and 73
>
> Dan
> K0DAN
>
>
> ______________________________________________________________
> LOGic mailing list
> Home: http://mailman.qth.net/mailman/listinfo/logic
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:LOGic at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html