[LOGic] Logic and K3

[Bill VanAlstyne W5WVO]

I am also using LOGic 8 with my K3, and it "works", sort of, using the K2 
support mode. It reads mode and VFO frequency. There is no native support 
mode for the K3, however, and there are a lot of things in LOGic that don't 
work right with the K3. For example, try switching to the B VFO, or setting 
the A and B VFOs to the same frequency, or going into Split mode using the 
buttons on the LOGic screen. You can't. Those LOGic functions don't work on 
the K3.

Now, you can say, OK, if you want to control all that stuff from the 
computer, you can interpose TRX Manager, which has elaborate native-mode K3 
support, between LOGic and the rig. True enough. But the controls mentioned 
above exist on the LOGic screen, and they work for directly supported rigs. 
They should work on the K3, and the K3 (as being one of the premier 
transceivers on the ham market today) should be supported with dedicated 
code. Why direct support for the K3 is still not considered a priority after 
all these years is a mystery to me.

Bill W5WVO


-----Original Message----- 
From: Joe
Sent: Tuesday, November 30, 2010 17:48
To: logic at mailman.qth.net
Subject: [LOGic] Logic and K3

I use Logic with my K3 with no problem.  In my set up, I am using Ham Radio
Deluxe and DM780 and I have an LP-PAN to run with SDR and a Steppir SDA 100
to control my Steppir vertical.  I connect to the K3 using N8LP's software
that allows sharing of serial ports.



If you just want to connect the K3 and Logic that would make it much
simpler.



Good luck and 73,



Joe AF1E

______________________________________________________________
LOGic mailing list
Home: http://mailman.qth.net/mailman/listinfo/logic
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:LOGic at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html