[LOGic] 6M Rig Support for IC-756Pro3

[R Johnson]

Hi Mel:

I had looked at the "Band" setup and saw that 6M phone was set for SSB and on
all the other phone bands were set for USB or LSB as appropriate.

I set 6M from SSB to USB and re-indexed. Problem was still there !!!

Today I found CW & RTTY spots for 6M and they set correctly.

The problem seems to be on just 6M Phone spots.

I haven't been able to find any other place in LOGic 8 where MODE info is defined.
Perplexed
Bob, K1VU


At 06:30 10/6/2008, you wrote:
>Just to clarify my answer...
>
>SSB is a valid mode if it as in the mode table, as far as log validation is concerned... but you can't set an Icom radio to SSB... it has to be set to USB or LSB. Check the modes in the band table.
>
>R Johnson wrote:
>>Hi:
>>I just got a IC-756Pro3 in June. Last weekend I installed a USB to Rig Interface.
>>Today I saw a few of 6M spots. Then things went downhill.
>>When I try to "Set Rig" to the spot  I get an error message:
>>"Attempt to Set Invalid Mode SSB".
>>I have checked the Mode and Band tables. All seems OK !!!
>>Further checking LOGic 8, Ver 8.0.89 will set the correct Mode on all bands
>>from 160M thru 10M.
>>On 6M it leaves the Rig in the same mode as it was previously set for,RTTY,CW,LSB,
>>or AM.
>>Strangely, if was SSB previous spot was SSB, I still get the same Error Message.
>>Am I doing something wrong or this a problem for Dennis ???
>>TIA
>>73
>>Bob, K1VU
>>_______________________________________________
>>LOGic mailing list
>>LOGic at mailman.qth.net
>>http://mailman.qth.net/mailman/listinfo/logic
>
>-- 
>Mel, VE2DC
>_______________________________________________
>LOGic mailing list
>LOGic at mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/logic