[LOGic] FT-1000mp Mark V Split Operation

[ken brookner]

i use an orion, n4py control software, and logic 8.  i see this same 
behavior.  really screws me up sometimes when i forget to check the mode 
the other vfo is in.  it would be nice if vfo b's mode did follow vfo a, 
or if logic had a switch to turn this behavior on or off.

kenb, ky5g

Ben N6FM wrote:
> That depends on the rig. If it is an ICOM, there may be a better choice for
> you to use in the menus. Same may be true of other models and manufacturers.
>
>
> Ben
>
> -----Original Message-----
> From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net]
> On Behalf Of Richard Thorne
> Sent: Sunday, March 16, 2008 5:31 AM
> To: Logic
> Subject: [LOGic] FT-1000mp Mark V Split Operation
>
> I just noticed that if I click on a spot that has a qsx frequency, vfo b 
> will stay in the mode it was prior. For example If I clicked on TX5C 
> transmitting on 14.025 and listenning up on 14.035, vfo a would go to 
> 14.025 cw but vfo b would go to 14.035 usb (if vfo b was last used on 
> usb).  I would think that vfo b would also receive a command to place it 
> in the proper mode.
>
> Has anyone else noticed this?
>
> Rich - N5ZC
>
>