[LOGic] K3 Support

[Greg]

Setting Logic for a K2 works for basic functionality.  I did experience some
problems with mode problems when clicking on a spot in spot log.  Dennis
tried working on it some but we did not have any luck.  There have been some
CAT changes since then but I don't know what's been done with them in logic.

73
Greg
AB7R


-----Original Message-----
From: logic-bounces at mailman.qth.net
[mailto:logic-bounces at mailman.qth.net]On Behalf Of Bill W5WVO
Sent: Sunday, July 20, 2008 3:56 PM
To: Logic
Subject: Re: [LOGic] K3 Support


I'm actually still running LOGic 7 (long story, don't ask) and
using the K2 driver for my K3. It basically decodes the mode
output from the radio and stays in sync with the A VFO, but you
can't do anything else, like switch between VFO A and B, assert
split mode, change transmission mode, etc., etc. The Kenwood
drivers basically have the same limitations as the K2 driver. The
LOGic 8 K2 driver might be a closer fit... Dunno.

Bill W5WVO

----- Original Message -----
From: "Richard Thorne" <rmthorne at suddenlink.net>
To: "Logic" <LOGic at mailman.qth.net>
Sent: Sunday, July 20, 2008 4:25 PM
Subject: [LOGic] K3 Support


> My K3 will be here this week.   If you have a K3 and Logic8,
which radio
> are you selecting for communication, the k2 or a Kenwood?
>
> Thanks
>
> Rich - N5ZC
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic

_______________________________________________
LOGic mailing list
LOGic at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/logic