[LOGic] Logic 8 and Microham Interfaces

[Roland Guidry]

Stan,

I have the exact same setup as you with the Pro 3, but using Microham Keyer
with USB too. The only difference in your configuration and mine is in
Logic. I have both DTR and RTS checked under rig control. 

Give it a try.

Roland NA5Q

Message: 7
Date: Mon, 11 Feb 2008 11:06:31 -0600
From: Stan <k9iuq at verizon.net>
Subject: Re: [LOGic] Logic 8 and Microham Interfaces
To: LOGic is open to all radio amateurs for discussion of LOGic
	logging	program <logic at mailman.qth.net>
Message-ID: <47B08097.8030203 at verizon.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Mel
Interface= Microham USB II
Version : USB device Router 5.1.1 - the latest version available at 
Microham website
Radio= Icom Pro III, Ci-V baud rate 19200, CI-V address 6Eh, Ci-V 
transceive On, Ci-V transceive with IC-731 off

Microham USB device router Set up:
Radio Com1,       CW Com5 DTR,    PTT Com5  RTS,        SQL none

This setup works flawlessly with over a dozen programs I have tried in 
the last 2 years.

Logic 8 goes into transmit when I load the program. Also goes into 
transmit when I access and exit the Rig setup menu. Also goes into 
transmit when I access certain other
menus like Utilitys.  Only way to get it out of transmit  is to remove 
the interface USB plug and re-insert. In Logic 8 I have radio1 setup as 
Icom  all, com1, 19200 2 stop bits Addr 6Eh, DTR and RTS not checked.

I dont have the CW keying setup in LOgic right now. Logic sends very 
poor CW, it stutters and sometimes shortens dits or dahs. I been using 
Mixw to send CW , since it sends perfectly. Mixw 2 uses the Com 3 port 
and is not setup for the rig control. I have tried running Logic 8 by 
itself thinking maybe MIXW was interfering but this is not the case.

I have tried other different setups both in Logic and the Device router 
with same results.

Thanks
Stan K9IUQ