[LOGic] Logic 8 and Microham Interfaces

[Mel Martin]

Logic uses far too many resources to generate reliable CW unless you 
have a fairly powerful computer. That is why I use the K1EL keyer and 
highly recommend it.

Why do you have RTS and DTR set to high on COM1... this could cause 
problems if this is a USB COM port. Its used to supply 5V to some level 
convertors...

Stan wrote:
> Mel
> Interface= Microham USB II
> Version : USB device Router 5.1.1 - the latest version available at 
> Microham website
> Radio= Icom Pro III, Ci-V baud rate 19200, CI-V address 6Eh, Ci-V 
> transceive On, Ci-V transceive with IC-731 off
> 
> Microham USB device router Set up:
> Radio Com1,       CW Com5 DTR,    PTT Com5  RTS,        SQL none
> 
> This setup works flawlessly with over a dozen programs I have tried in 
> the last 2 years.
> 
> Logic 8 goes into transmit when I load the program. Also goes into 
> transmit when I access and exit the Rig setup menu. Also goes into 
> transmit when I access certain other
> menus like Utilitys.  Only way to get it out of transmit  is to remove 
> the interface USB plug and re-insert. In Logic 8 I have radio1 setup as 
> Icom  all, com1, 19200 2 stop bits Addr 6Eh, DTR and RTS not checked.
> 
> I dont have the CW keying setup in LOgic right now. Logic sends very 
> poor CW, it stutters and sometimes shortens dits or dahs. I been using 
> Mixw to send CW , since it sends perfectly. Mixw 2 uses the Com 3 port 
> and is not setup for the rig control. I have tried running Logic 8 by 
> itself thinking maybe MIXW was interfering but this is not the case.
> 
> I have tried other different setups both in Logic and the Device router 
> with same results.
> 
> Thanks
> Stan K9IUQ
> 
> 
> 
> 
> 
> Mel Martin wrote:
>> Stan... it is good... but a little intermittent at times.
>>
>> What's up with your Microham Interface? I use the Microkeyer with my 
>> Icom 781 and 749Pro and works like a charm...
>>
>> Which one are you using?
>> How's it configured? PTT lines etc...
>> Have you loaded the latest firmware?
>>
>> I can see if it's comparable to my set-up here
>>
>> Mel...
>>
>> Stan wrote:
> 
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic
>