[LOGic] ADIF export

[Bill W5WVO]

Mark,

If you go to Tools >> Setup >> Log Fields..., you will see all the various 
LOGic log fields, and each field has a character in the Type column. There is 
no "binary" type in LOGic-ese; the only thing I can think of that TRX might be 
talking about is Float (floating-point decimal value). If TRX gives you no 
clue as to which field name it is objecting to, you might try by disabling 
export of all Float fields -- but this would eliminate exporting the 
frequency, among possibly other things. Just have to try it and see if that is 
what it is complaining about. In the Log Fields window, quite a bit to the 
right of the Type column, you will also see the ADIF name for that field as 
well as a Boolean (T or F) that turns export for that field on or off. Just 
set all Float fields to F and try exporting again.

NOTE: This may be all completely wrong-headed. :-)

Bill W5WVO


Mark Klocksin wrote:
> I had a hard drive failure, but...I had a current back-up file of my
> log!  After I got everything set up again, I thought I was all set.  I
> did a "restore" from my back-up and all the Q's were there!  Whew!
>
> Next I tried exporting my LOGic log to TRX-Manager.  I created the
> ADIF file.  But when I tried importing it to TRX-Manger, I got the
> following error message:
> "Binary field found.  ADIF import aborted.  Turn off export of any
> binary field from LOGic."
>
> Well, for starters, I can't find any way of identifying which fields
> might be binary.  And if I could, then any tips on how to selectively
> turn it/them off?
>
> Thanks and 73,
> Mark WA9IVH
>
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic