[LOGic] Omni VII and Logic 8

[Greg Hodsdon]

Tim,
I use LOGic 8 with the Omni VII very successfully through the Pegasus
interface file. However, N4PY's control program must be running concurrently
to create the interface file.

Greg, K7KJ
Portland, OR

-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net]
On Behalf Of NZ8J
Sent: Sunday, December 23, 2007 4:52 AM
To: logic at mailman.qth.net
Subject: [LOGic] Omni VII and Logic 8

I am trying to interface Logic 8 to my Ten Tec Omni VII and just can't
seem to make it happen.  There is no specific "Omni VII" option to pick
from, I've been told to use the Pegasus interface file.  I pick that one
out of the list, set up the parameters, but I always get an error that
says "mismatch" or some other equally mystifying message. It locks up
Logic and it takes a bit to get it going again. I'd like to hear from
anyone who has used Logic with an Omni VII.  

I've been able to interface Logic with just all the other rigs I've had
here successfully, however this one is giving me a problem.

Any help would be appreciated.

Thanks 
Tim
NZ8J
_______________________________________________
LOGic mailing list
LOGic at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/logic