[LOGic] Skip radio at startup?

[mel martin]

I've been asking for a fix to this for a LONG time... I have 3 Icom radios
hooked up and it takes FOREVER for the damn program to start if 2 are off...
Which is often the case. The wait for the Yaesu FT900 when configured is
much less than the Icoms.

It's much master if the COM port is not available... But it waits... And
waits... And waits for the radio.... One at a time Grrrrrr!

> -----Original Message-----
> From: logic-bounces at mailman.qth.net 
> [mailto:logic-bounces at mailman.qth.net] On Behalf Of Brian Smithson
> Sent: September 6, 2006 06:02
> To: logic at mailman.qth.net
> Subject: [LOGic] Skip radio at startup?
> 
> 
> Good morning!
>  
> I have LOGic configured to work with my Mark-V. But when I 
> start LOGic without the rig turned on it locks up for about 
> 30 seconds while the radio times out. I'm just getting 
> started with LOGic, importing, etc so I find myself getting 
> in and out of LOGic without the radio a lot. Is there a way 
> to start the program without it trying to connect to the 
> radio? Something like holding down the shift key like Windows?
>  
> 73!
>  
> -Brian n8wrl
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net http://mailman.qth.net/mailman/listinfo/logic
> 
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.11.7/438 - Release 
> Date: 2006-09-05
>  
> 

-- 
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.11.7/438 - Release Date: 2006-09-05