[LOGic] Rotor STOP issues in 7.0.155

[Ben Hatheway N6FM]

Dennis has fixed the rotor issue I reported here this past Friday with an
update. It now works great. 

This is what you call REAL customer service. It was fixed less than two days
after I reported it, and over a weekend yet. 

It doesn't get any better than that. 

73

Ben N6FM
Happy Logic user.


-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net]
On Behalf Of Ben Hatheway N6FM
Sent: Friday, September 16, 2005 4:20 PM
To: pdainc at hosenose.com
Cc: logic at mailman.qth.net
Subject: [LOGic] Rotor STOP issues in 7.0.155



I have just upgraded from 7.0.141 to 7.0.155. Now, when pressing STOP to
stop the rotor on either the spot log, the Rotor control window, or the map,
the error "Property ROTOR3REF is not found". 

There is no rotor 3 defined, only rotor 1, which is Sartek 1B, and had been
working fine. The rotor DOES stop. 

Clicking "ignore" a couple of times causes the message to go away. 

Anyone else experience this??

Thanks

Ben
N6FM


_______________________________________________
LOGic mailing list
LOGic at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/logic