[Logic] ERROR MSG - SPOT LOG

[Michael D Rand]

HI

I have Logic7 connected to my radio to enable me to tune my IC-751A from my 
computer.  This arrangement permits to set my rig's frequency frequency to 
match that of the highlighted record in the Spot Log.

The following paragraph describes a minor annoyance I am experiencing.  I 
can live with it but would like to remove it.  Any suggestions?

Unfortunately, when I attempt to set my rig frequency from the Spot Log, I 
immediately get an error message sating:  "Attempt to access  invalid mode 
SSB".  I can either wait about 3-4 seconds and the error message will 
disappear and the rig's frequency will change as desired OR I can click 
immediately on the "OK" button in the error message window and the message 
will disappear and the rig's frequency will change as desired without 
further delay.

Have I overlooked something?

Shalom from, to and for Israel,

Mike Rand, 4Z1MR / N7NPR
POB 1182
Kfar Vradim 25147
ISRAEL

Home Phone:      04-957-4922
Pella/Cellphone: 053-278-9763 (new)
(From the U.S. dial 011-972 - omit the 1st 0 - then dial rest of the phone 
number)