[Logic] Power - Carry Value Forward to New Record????

[Carl Smidt]

Good one Margo, didn't think of that. Thanks.

73,   Carl   VE9OV


----- Original Message ----- 
From: "KG8MS" <kg8ms at sbcglobal.net>
To: "LOGic is open to all radio amateurs for discussion of LOGic logging 
program." <logic at mailman.qth.net>
Sent: Friday, February 25, 2005 2:29 PM
Subject: Re: [Logic] Power - Carry Value Forward to New Record????


> Hi Mike
>
> If you have no default power level set the default becomes whatever 
> you had in the previous QSO. You just have to  remember to change it 
> with the first QSO. Hope this helps.
>
> 73, Margo KG8MS
>
> Michael D Rand wrote:
>
>> HI All.
>>
>> I'm using LOGic7 and have the default power level set at 100. 
>> However, I often use an amplifier  and transmit at higher power 
>> levels.  Once I tune the amplifier and leave it on, I often use it 
>> for several contacts.  My problem is that whenever I initiate an 
>> entry for a new contact, the entry in the power field reverts to 100. 
>> I would prefer that once changed it should carry forward the latest 
>> value entered.  Even if with is no default for the initial log entry, 
>> that would be better;  I would prefer to make an entry when I first 
>> turn on LOGic7, rather than have to constantly change it from the 
>> default when I operate with the amplifier on.
>>
>> Have I overlooked something?  Comments please.
>>
>> Shalom from, to and for Israel,
>>
>> Mike Rand, 4Z1MR / N7NPR
>> _______________________________________________
>> LOGic mailing list
>> LOGic at mailman.qth.net
>> http://mailman.qth.net/mailman/listinfo/logic
>>
>
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic
>
>