[Logic] SERIAL PORT ERROR?

[Mel]

Running Logic and other programs I have run into issues when a port was not
closed after exiting the program... But I can't remember which program was
at fault...

> -----Original Message-----
> From: logic-bounces at mailman.qth.net 
> [mailto:logic-bounces at mailman.qth.net] On Behalf Of k0dan
> Sent: September 7, 2004 23:44
> To: logic at mailman.qth.net
> Subject: [Logic] SERIAL PORT ERROR?
> 
> 
> Hi folks...
> 
> Been running LOGic6 for several years, including rig 
> interface. All OK.
> 
> Recently purchased LOGic7, and am running both 6 and 7 from 
> different directories during the transition debugging.
> 
> Suddenly, the rig interface no longer works. The error I get 
> is a pop-up window stating A TIMEOUT OCCURED WHILE ATTEMPTING 
> TO COMMUNICATE WITH A RIG. MAKE SURE RIG IS TURNED ON AND 
> CHECK SETUP PARAMETERS. POLLING DISABLED. 4 CHARACETRS IN 
> BUFFER. F0-40-02-00.
> 
> The rig is powered up, cable is OK, and setup parameters are 
> unchanged. In fact nothing is changed.
> 
> The error pops up if I start LOGic6 or LOGic7. I am speaking 
> of a problem when running only ONE of the LOGic programs; of 
> course both simultaneously will not share the COM port.
> 
> I believe this propblem only cropped up since I installed 
> LOGic7 in a new directory.
> 
> Any ideas what is going on here?
> 
> Thanks and 73
> Dan
> K0DAN
> 
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net http://mailman.qth.net/mailman/listinfo/logic
>