[Logic] Report Modification

Thu, 26 Sep 2002 00:54:33 -0400

Finally found it!  File, Set Up Report then select report to modify and
place the focus on it; back to File and Page Set Up.  Then you can change
the left margin.  Worked OK but then I found that the entirety of the
printed material is shifted toward the bottom of the label.  Didn't think it
looked so good.  Think I will go back to what I was using, ie, the smaller
print.  Thanks for the input.

Dean  --  W4IHK

-----Original Message-----
From: Joe Dubeck <[email protected]>
To: [email protected] <[email protected]>; [email protected]
<[email protected]>
Date: Wednesday, September 25, 2002 5:04 PM
Subject: Re: [Logic] Report Modification

>Far left menu selection I recall.  Go to FILE>PRINT (or is it just
>PRINT?).  When you click on PRINT, an option opens to either PRINT or
>MODIFY a report.  I didn't expect to see "modify" under the print selection
>but it's there.
>
>-Joe, NA9A
>
>At 04:20 PM 9/25/02 -0400, Dean Craft wrote:
>>Several months ago someone noted that when printing QSL labels with the
>>'larger type' selection that the very first character was not printed
>>completely on some laser printers.  The fix was identified as simply going
>>to 'Modify Reports', selecting 'File' and changing the setting of 'Left
>>Margin'.
>>
>>What option or process is the 'Modify Reports' section under?  For the
life
>>of me, I cannot find it!  Is that option only available under version 6?
I
>>am using the last version/build of 5.
>>
>>Dean  --  W4IHK
>>
>>
>>
>>_______________________________________________
>>LOGic mailing list
>>[email protected]
>>http://mailman.qth.net/mailman/listinfo/logic
>
>_______________________________________________
>LOGic mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/logic