[Logic] Sartek Rotor Control Wireing - Help

Sun, 27 Jan 2002 22:09:02 -0700

BlankRichard....the fellow who had a major design role with the Sartek rotor
control is Al Parsons -VE6RFM.
He is in Fort McMurray, Alberta.
E-mail Address(es):
[email protected]
 Phone 780- 791-1782

----- Original Message -----
From: Richard Thorne
To: [email protected]
Sent: Sunday, January 27, 2002 5:15 PM
Subject: [Logic] Sartek Rotor Control Wireing - Help

Hello Group:

I plan on using my Sartek rotor control to use on my Yaesu G1000SDX.  I had
it wired and hooked up in the past but de-installed it.

I'm now rebuilding my remote controlled station and plan on using the rotor
control again.  However, the plug that came with the unit that plugs into
the yaesu edge connector inside the rotor control head had two of the four
wires pull out of the edge connector.

Can some one assist me with which wires go where?  I cannot locate my
manual.

Thanks in advance.
Rich Thorne
ARS: N5ZC
AMA: N5ZC
Amarillo, TX
http://www.tcac.net/~rthorne/index.html