[Logic] Error in Logic 6.0

Sat, 20 Apr 2002 09:08:03 -0400

I am experiencing a similar problem, but not quite the same. Mine only
happens when the 1010 number is a high number. In other words, The 1010
automatic lookup (or manual) works fine until the 1010 number happens to
be one of the higher numbers (60,000 or higher). Then I get the error
message described below. Sometimes I can recover from that though. I
suspect it is a corruption of the 1010 list and was going to wait and
see if the next 1010.txt has the same issue. Perhaps the corruption
takes place during import? My platform is WinXP Professional 384MB RAM
on a 1ghz workstation.

Best 73 de N3MX...STEVE

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Roland Guidry
Sent: Saturday, April 20, 2002 8:39 AM
To: [email protected]
Subject: [Logic] Error in Logic 6.0

I am have difficulty with this new program, Logic 6.0 Build 6.0.104.
When my
cursor passes over the userfield 1010#, I get an error as shown with the
attached gif pic. When I chose "no" the program exits and when
restarted, I
have to perform a clean then restart.

Sometime I get an error message that says "Invalid Subscript Reference"
Cancel or Ignore. If  I "Ignore" program continues to run, if I cancel I
get
other errors reported.

The file I downloaded for 1010#'s came from Win1010 using their 1010.txt
file. I do not have this problem with Logic 5.

Has anyone encountered this same problem. I email [email protected] on
4/18,
no response to date.

Roland, WA5CHX

_______________________________________________
LOGic mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/logic