[Laser] Laser Analog Signal Digitizer PCB

Sat, 11 Jan 2003 20:58:51 -0800

>From Tom Upton AD6N
Please, below:

robotics wrote:

> Friends
>
> I have planned a highly sensitive Large Area Laser Sensor, Laser Sensor
> Signal Amplifier and Digitizer on a Printed Circuit Board within US$250
> range.
>
> Sensor has an active area of 10mmx10mm.
>
> Frequency response of 250kHz is planned. A 16-bit ADC with 250ksps has been
> selected.
>
> Wavelength response from 300nm to 1000nm range unless specific wavelength is
> of interest and is band pass thru.
>

Wavelength depends on the sensor, doesn't it?  For example, an infrared sensor
is not nearly as sensitive in the red or the green area of the spectrum.  It
seems difficult to cover 300nm to 1000 nm unless one has more sensors than one.

> I will keep you informed about the development.
>

Please do keep us informed!

Tom Upton  AD6N

> Those of you seriously interested in it may write to me separately if your
> interest is different from that of the forum members.
>
> Regards.
>
> Shyam
>
> =======================================
> Shyam Sunder Tiwari
> Managing Director
> Sensors Technology Private Limited
> AM-51, Deen Dayal Nagar
> Gwalior, MP 474020, India
> Phone: +91-751-2470680 / 5045715
> Fax:+91-751-5045716
> Email: [email protected]
> http://sensorstechnology.tripod.com/
> Planning to visit Gwalior ? Information....
> http://www.calindiatours.com/gwali.htm
> =======================================
>
> _______________________________________________
> Laser mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/laser