[Kenwood] TS-530S HV

[howard holden]

Should be around 800V +/-. Should also show on the meter in the HV position.

Howie WB2AWQ

________________________________________
From: kenwood-bounces at mailman.qth.net on behalf of k3ac--- via Kenwood
Sent: Wednesday, February 12, 2025 3:52 PM
To: Dennis Younker NE6I; kenwood at mailman.qth.net
Subject: Re: [Kenwood] TS-530S HV


750 volts DC is nominal for the 6146b
Bob K3AC


Sent from the all new AOL app for iOS


On Wednesday, February 12, 2025, 6:48 PM, Dennis Younker NE6I <NE6I at cox.net> wrote:

Does anyone know what voltage I should have as measured with a DVM on the
plates of the 6146B tubes in a TS-530S? I have one here that registers Drive
but no HV on the meter and no RF output. No RF output on my external
wattmeter either. The tubes are lit up when the Heater switch is on. The
service manual doesn't seem to show what that HV should be.



The receiver works FB and I was listening to a pileup on 15 CW for V73WW
just now.



--Dennis NE6I

______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Kenwood at mailman.qth.net

This list hosted by: http://www.qsl.net/
Please help support this email list: http://www.qsl.net/donate.html



______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Kenwood at mailman.qth.net

This list hosted by: http://www.qsl.net/
Please help support this email list: http://www.qsl.net/donate.html