[Kenwood] TS2000 ACC2 jack and power out

[John Dize]

Not a problem for me . But I use signalink usb and my wsjt 2 will not recognize at 2000. In radio block I put none. Vox for Tx and it works. With no delay in Tx. I don’t understand why but it doesn’t see 2000

Get Outlook for iOS<https://aka.ms/o0ukef>
________________________________
From: kenwood-bounces at mailman.qth.net <kenwood-bounces at mailman.qth.net> on behalf of John Geiger <af5cc2 at gmail.com>
Sent: Thursday, February 11, 2021 12:37:37 PM
To: kenwood at mailman.qth.net <kenwood at mailman.qth.net>
Subject: [Kenwood] TS2000 ACC2 jack and power out

I recently purchased a used Kenwood TS2000, made in January 2012.  I am
looking at getting it on FT8 and other digital modes, but have found a few
old postings on the internet stating that when using the ACC2 jack for
audio in on the digital modes, it takes 3 to 4 seconds to reach full power
on transmit.  I have had a TS2000 in the past and used it with a Signalink
USB interface and can't remember if this was a problem with it or not.

Is that a common problem for all TS2000s?  Did they fix it at some point
and does anyone know the serial number range or firmware version where this
issue was fixed?

73 John AF5CC
______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Kenwood at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html