[Kenwood] Kenwood HF Xcvr, PS, Filters, Mics, Spkrs, and more FS

[Ken, W8EK]

Kenwood Items For Sale:
HF + 6 meter Transceiver, Power Supply, Crystal Filters,
Microphones, Speakers, Cables and more
.
.
Kenwood TS-570SG, HF + 6 meters:

The Kenwood TS-570SG provides DSP technology for superb audio,
noise reduction, equalization and slope tuning. In SSB/AM/FM modes
you can select a Hi/Low cut DSP slope tune using 441 possible
combinations. In CW and FSK the DSP alters the passband width
for rejection of nearby signals.

It covers the amateur bands from 160-6 meters, plus a general
coverage receiver. Power output is from 5 to 100 watts. A preset
auto antenna tuner and electronic keyer are built in. The menu
system offers 46 types of functions. Full and semi break-in,
dedicated packet port, 57600 bps PC control, Keypad entry, 100
memories, IF shift, Scanning and CW Auto Tune are included.

This is the S G model with 6 meters and all of the latest
DSP features.

This rig works 100% and is a 9.9 cosmetically.
With hand mic, power cord, and manual for $675.
.
.
Kenwood PS-53 Power Supply

The Kenwood PS-53 power supply provides 13.8 VDC at
20.5 Amps (max continuous operation one hour) or 22.5
Amps at 25% duty cycle. Input is 120 VAC 60 Hz. Ripple
voltage is less than 20 mV rms (at 13.8 VDC 16A).
Regulation is ± 0.7 V at 10% input variation at 16 Amps.
Power consumption is 550 watts. This power supply features
a tilt bar. There are terminals for output on the back panel.
6.8 x 4.4 x 12.6 inches 15.2 lbs.

It works great and looks fine.

With Paper work for only $150.
.
.
Kenwood "Plug In" Crystal Filters:

All are for the 8.83 MHz IF, work 100% and look like new.
Paper work is included.

These are "plug in filters" as opposed to the type that must
be soldered in. They are used in rigs such as the TS-450, TS-570,
TS-690, TS-850, TS-930, TS-940, TS-950, and others.

Kenwood YK-88 C 1 Crystal Filter
500 Hz wide for CW and narrow digital.
Fits rigs as listed above. $79

Kenwood YK-88 S 1 Crystal Filter
This plug in filter is 2400 Hz wide and is used in the same
rigs as listed above. $75
.
.
Kenwood Microphones
.
.
Kenwood MC-60 A, Deluxe Desk Microphone:

The Kenwood MC-60A is a communication type dynamic unidirectional
mic. It features UP-DOWN tuning. The mic impedance may be set for
50K ohms or 500 ohms. The frequency response is 150 Hz to 10 kHz
(-6dB) with the Preamp off and 200 Hz to 7 kHz (-6 dB) with the
Preamp on. The heavy zinc die-cast base provides extra stability.
The mic terminates to a standard round 8 pin mic plug. It can be
used on virtually any of the Kenwood rigs that use a round 8 pin
connector. Please note that the earlier MC-60 (non-"A") version
has a 4 pin mic plug and no UP-DOWN tuning.

This particular mic appears to be new, unused. It came from a SK,
so I can not verify for sure, but it certainly looks new, and of
course works like new.

This is a current model and sells for about $160. Buy this one
for only $100.
.
.
Kenwood MC-43 Hand Mic

Has round 8 pin plug, with up/down switches.
Used on most of the Kenwood rigs with round 8
pin plugs.
Works 100% and looks like new. $40
.
.
Kenwood MC-85 Deluxe Desk Microphone Parts:

The Kenwood MC-85 will take up to three mic cords,
i.e. it is capable of being used on three rigs.

MC-85 desk mic "Tech Special"
It looks like the silent key was working on repair of this when
he passed. All parts appear to be present, plus the addition
of a couple extra up/down switches. $45
.
.
Kenwood SP-23 External Speaker:

The Kenwood SP-23 base speaker matches many Kenwood
transceivers including the TS-450S, TS-570S/D and TS-690.
This versatile 8 ohm speaker features a metal cabinet with
flip-out tilt bar. It has a 3 inch (77 mm) speaker element
rated to 1 watt, with a 300 to 5000 Hz response. The rear
panel features two screw connections, and includes a 3 foot
audio cable.

It is 4.8 x 3.75 x 9.25 inches, and weighs 2.8 lbs.

This particular speaker works fine, and looks like new. It
is in its original box, with cable and paper work for only
$75.
.
.
Communications Speakers:

Motorola Communications Speakers
These are designed to go with Motorola's commercial commun-
ications systems. They are about 5 inches square and 3 inches
deep, and black in color, terminated with an 1/8 inch (3.5 mm)
plug. Superb communications quality. Gimbal mounting bracket.
These work 100% and look like they have not been used.
Several available. $35 each.

Realistic 21-549 A
This speaker is about 4 inches square and about 2 inches deep. It
is rated for 5 watts, has an 8 ohm impedance, and is listed as a 300
to 3000 Hz frequency response, making it ideal for communications.
It has a 3.5 mm (1/8 inch) mono plug, as used by most modern rigs.
It is black in color, looks great, and sounds great. $12

Wilson Speaker
Appears to be the same as above, except beige color. $12
.
.
Linear Amp Switching Cables for Kenwood Rigs:

This cable goes from a Kenwood transceiver to a linear
amplifier to switch the amp from transmit to receive.

One end has a DIN connector, as is used with most Kenwood
rigs. The other end has an RCA phono plug, as used by most
linear amplifiers.

Before using this cable, please check the switching
capabilities of your transceiver, and the requirements
of your amplifier.

Cable for switching the T/R relay. Only $15.

Cable as above, but with ALC line in addition to T/R switching.
$20
.
.
Kenwood "Extension Feet":
This is a set of two feet that are often used on
various Kenwood rigs to raise the front by about
1/2 inch to give a rig, speaker, remote VFO, etc.
the tilt that makes it easier to read.
This is a complete set of two front feet, with the
needed hardware. $15
.
.
Other Kenwood Items, such as manuals and original boxes,
are also available.
.
.
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400