[Kenwood] HF Xcvr, Filters, Cables, Manuals, and more FS

[Ken, W8EK]

Kenwood HF Transceiver, Crystal Filters, Power Cord,
Linear T/R switching cable, Desk and Hand Microphones,
HT accessories, original boxes, original manuals, and more


Kenwood TS-450 S AT, HF Transceiver:

The Kenwood TS-450 is a formidable transceiver covering 160
through 10 meters including the WARC bands with 100 watts
(40W AM). An internal automatic antenna tuner is included.
The TS-450 supports many advanced features such as keypad
entry, VOX, 100 memories, XIT, RIT, Notch, IF Shift, Squelch
and digital meter. It requires 13.8 V DC at 20.5 amps.

Features:
160-10 meters
AF Notch
CW Reverse
100 Memories
Dual Mode NB
XIT/RIT
IF Shift
Keypad Entry
All Mode Squelch
RF Speech Processor

This particular rig works 100% as best I can tell.
Cosmetically, it is good.

With mic, power cord, and paper work for $450.


Kenwood Crystal Filters:

Kenwood YK-88 S 1 Crystal Filter:
This filter is 2400 Hz wide.
This is a "plug in filter" as opposed to the type that must
be soldered in. It is used in rigs such as the TS-450, TS-570,
TS-690, TS-850, TS-930, TS-940, TS-950, and others.
It is for the 8.83 MHz IF.
It works fine and looks like new.
Paperwork is included for $75.

Kenwood YK-88 SN
This is the "solder in" type filter that is used in the TS-130,
TS-430, TS-440, TS-530, TS-830, R-5000, and many others.
It is 1800 Hz wide making it ideal for narrow SSB, but also
for digital modes. It works fine and looks like new. $70


DC Power Cable:
This is the heavy duty power cable as used on most of the
Kenwood HF rigs, plus also many Icom, Alinco, and others.
It has the 6 pin molex connector, with four pins used - two
for plus and two for ground.  It looks good, and of course
works fine. $22


Cable for T/R switching if linear amplifiers:

This cable goes from a Kenwood transceiver to a linear
amplifier to switch the amp from transmit to receive.

One end has a DIN connector, as is used with most Kenwood
rigs. The other end has an RCA phono plug, as used by most
linear amplifiers.

Before using this cable, please check the switching
capabilities of your transceiver, and the requirements
of your amplifier.

Cable for switching the T/R relay. Only $15.

Cable as above, but with ALC line in addition to T/R switching.
$22


Kenwood MC-85 Deluxe Desk Microphone:

The Kenwood MC-85 is a deluxe unidirectional electret
condenser desk mic. In addition to it being a microphone,
it features UP-DOWN tuning for compatible Kenwood
transceivers. It also has built-in audio level compensation,
preamp and a level meter.

It can be used with up to three different rigs. This one has
one 8 pin mic cable.

This mic requires power that is derived from most Kenwood
rigs that use the round 8 pin connector. For other models,
you will need to install four AA cells (not supplied).

This 700 ohm mic has a 300 to 7000 Hz response.

This particular mic works fine and looks like it just came out
of its box new. No defects.

Paper work is included for $100.


Extra Cables for MC-85 Microphones:

With 4 pin plug, such as used on TS-130 and others. $20

With round 8 pin plug, as used on TS-430 and others. $20


MC-85 desk mic as above, but "Tech Special"
It looks like the silent key was working on repair of this when
he passed.  All parts appear to be present, plus the addition
of a couple extra up/down switches.  $45


Hand Microphone with round 8 pin plug for Kenwood, Alinco, etc.

This hand mic works great on most Kenwood rigs with the
round 8 pin connector, such as the TS-430, TS-440, TM-241,
TM-2530, TW-4000, and others, including Alinco and ADI.
It says "Electret Condenser Mic" on the back, and
"Kenwood" on the front, with no model number.

Basically, this mic functions like an MC-43, with a couple
more features. It has the mic and PTT switch; it also has
up/down switches on the top. There are four "extra" buttons
labeled Call, VFO, MR, and PF. What these four buttons do
depends on the rig. There is also a "Lock" switch on the back.

Regardless if you use the four extra buttons or not, you
still have a mic that works like an MC-43.

This mic works fine, and looks like new. I am guessing it
came with a rig, and was immediately put in the drawer,
and never used. $30


Accessories for the Kenwood TH-21 / 31 / 41 series HTs:

Kenwood SC-8 T "Soft Case" for any of the TH-21 series HTs
Appears to be unused, $12

Antenna adapter that fits the TH-21 series HTs, and has an SO-239
on the other end, to accept a PL-259. $5

Antenna adapter that fits the TH-21 series HTs, and has a BNC on
the other end. $8

Original Operating manual for TH-21 HT for 2 meters $8

Original Box, with inserts, for Kenwood TH-41, 440 MHz HT. $8

Kenwood W09-0315 charger
This charger is used to charge the larger PB-21 H batteries for
the TH-21 series, and also on other Kenwood radios.
It has a standard 2.1 mm coaxial connector. $12


Kenwood "Soft Cases"

SC-35 soft case
For Kenwood TH-78 dual band HT. Looks like new.
Only $12.

SC-8 T soft case
For Kenwood TH-21, TH-31, TH-41 series HTs.
Like new condition. $10



Original Boxes for Icom IC-V8 HT, Icom IC-27 mobile,
Kenwood TM-221 mobile, Kenwood TH-41 HT, Kenwood TR-2600 HT,
and ADI AT-200 HT, complete with inserts. All of these boxes
include all of the inserts they came with originally, and are
in close to new condition.

Original Box for Icom IC-V8 HT. $8

Original Box for the IC-27 two meter mobile transceiver.
Also includes the cardboard box for accessories that acts as
a spacer. $9

Original Box for Kenwood TM-221 two meter mobile transceiver. $6

Original Box for Kenwood TH-41, 440 MHz HT. $8

Original box for Kenwood TR-2600, Two meter HT. $8

Original Box for ADI AT-200, Two meter HT. $8


Original Manuals for Kenwood equipment:

All manuals are in very nice condition, for Kenwood equipment.
All are Operating manuals unless otherwise specified.
All are original manuals only.

SPECIAL:
Buy two, three, or four of my books/manuals, and take 10% off.
Buy five or more and take 20% off.

TH-21 HT for 2 m, $8
TH-215/315/415 HT for 2 m, 220 MHz, or 440 MHz, $10
TH-225, 2 m HT, $12
TH-241/441/541 mobile FM transceivers
...For 2 m, 440 MHz, & 1200 MHz, $12
TM-221/421 2 m or 440 MHz mobile, $12
TM-261/461 2m or 440 MHz mobile, $12
TR-2400, 2 m HT, $12
Service manual for TR-2600, 2 m HT, $12
TS-120 S/V, HF xcvr, $18
TS-450 "External Control" (not operating manual) $7
TW-4000 dual bander mobile, $15
Service manual for TW-4000 dual bander $20
TW-4100 dual band mobile, $15

BC-2 Wall Charger $2
BC-5 DC to DC quick charger $2
DC-21 Dc-DC Converter $2
LF-30A Low Pass Filter $4
MC-30 & MC-35 hand microphones $4
MS-1 mobile stand $3
PB-1, PB-2, PB-3, & PB-4 battery packs $2
PB-21 Battery Pack $2
PB-24 battery pack for TR-2400 $2
PB-25 H battery pack for TR-2500 $2
PS-6 power supply $5
PS-30 power supply $4
SC-8 / 8T Soft Case $2
SMC-24 speaker mic $2
SMC-25 speaker mic $2
SP-820 Speaker $2

These are original Kenwood manuals only.


Kenwood Operating Manuals in "Non English" Languages:

All of the following manuals are not in the English language.
They are the original Kenwood operating manual only.
They look quite extensive and detailed, and are basically new,
only being opened to observe that it is something I can not read.
They are all original from Kenwood and are all $8 each.

Kenwood TH-22 A Two Meter HT
Spanish Version for the TH-22 A / 22 AT / 22E and
TH-42 A / 42 AT / 42 E

Kenwood TH-22 A Two Meter HT
French Version for the TH-22 A / 22 AT / 22E and
TH-42 A / 42 AT / 42 E

Kenwood TM G-707 dual band transceiver
Spanish version of the TM G-707 Operating Manual


I also have many other accessories of many different
brands available.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400