[Kenwood] Kenwood Items FS

[Ken Simpson, W8EK]

Kenwood Items For Sale:


Kenwood TS-450 HF Transceiver:

The Kenwood TS-450S is a formidable transceiver covering
160 through 10 meters including the WARC bands with 100 watts
input (40W AM). The TS-450S supports many advanced features
such as keypad entry, VOX, 100 memories, XIT, RIT, Notch,
IF Shift, Squelch and digital meter. This radio has a carry
handle. Requires 13.8 VDC at 20.5 amps. Digital Signal Processing 
(DSP) in both transmit and receive modes (with optional DSP-100 
installed) provide greatly enhanced signal purity.

Features
     160-10 meters
     AF Notch
     CW Reverse
     100 Memories
     Dual Mode NB
     XIT/RIT
     IF Shift
     Keypad Entry
     All Mode Squelch
     RF Speech Processor

This particular unit works great, and looks great also.
Paperwork is included for $450.


Kenwood TS-130 HF SSB / CW transceiver:
This rig covers 80 thru 10 meters, including the WARC bands.
It has about 100 watts out, with slightly lower on 12 and 10
meters. Of course it has IF shift, speech processor, and other
features. It is all solid state.
This one works fine, and looks fine. With paper work for $350.

Kenwood PS-30, 20 amp (at 13 V DC) power supply:
This power supply will furnish up to 20 amps at 13 V DC to power
most 100 W output HF transceivers. It also has auxiliary
terminals on the back to power an additional rig, such as a
2 m rig. The main connector is the 6 pin molex connector
that will match most Kenwood, Icom, and Alinco HF radios,
as well as some Yaesu.
This particular unit works 100% and looks very nice.
Paper work included for $90.

Buy both the TS-130 and PS-30 above for $425.


Kenwood HS-4 Communications Headphones:

The Kenwood HS-4 is a set of headphones that completely
cover the ear to block out extraneous noise. They are
designed for communications effectiveness, and have an
8 ohm impedance to match most any rig. Of course these
are mono headphones and not stereo.

They have a standard 1/4 inch plug.

These work fine and look very good as well. No rips or
tears in the headphone covers. $30


Kenwood SP-520 Speaker:

This speaker matches the TS-520, TS-530, and other Kenwood
rigs, although it certainly can be used with almost any
radio one would want.

This particular one works fine, and looks very good. It has
a couple of very light scratches on the sides that are barely
visible.

Paper work is included for $55.


Kenwood MC-43 S hand microphone:

This is the "standard" microphone that came with many of
the Kenwood rigs that take the round 8 pin mic connector,
which is what this one has on it.
It has "up" and "down" switches, as well as the normal
PTT switch.

This particular MC-43 is in extremely nice condition. It
looks close to new, with no scratches on it.

Paperwork is included for $40.


Deluxe Desk Microphone w/ Kenwood 8 pin connector:

This is a great looking and great performing low impedance
desk mic. It has a quality Shure 600 ohm cartridge in it
(the cartridge alone is over $40 new), with a very nice
black die case base and neck, with a chrome grill. It
looks somewhat like a Shure 444, but no plastic on this
one -- all metal!

This one looks like new, and works the same. It has a
long (approx 6 foot) cord, with a round 8 pin connector
for Kenwood. $75


Kenwood Hand Microphone with round 8 pin plug:

This hand mic works great on most Kenwood rigs with the
round 8 pin connector, such as the TS-430, TS-440, TS-570,
TM-241, TM-2530, TW-4000, and others.
It only says "Electret Condenser Mic" on it, with no
model number.

Basically, this mic is like an MC-43, only with a couple
more features. Of course it has the mic and PTT switch;
it also has up/down switches on the top. There are four
"extra" buttons labeled Call, VFO, MR, and PF. What these
four buttons do depends on the rig that it is attached to.
They will function on some rigs, and are completely useless
on others. There is also a "Lock" switch on the back.

Regardless if you use the four extra buttons or not, you
still have a mic that works like an MC-43.

This mic works fine, and looks like new. I am guessing it
came with a rig, and was immediately put in the drawer. $30


Kenwood Mic with modular connector:

This mic is basically the same as the one with the round
8 pin connector above, except it has the modular plug on it,
as used by the TM-261, TM-271, and many others.
It looks like new.  $30


CW Keyer and Bencher Paddles:

MFJ 422 B X electronic keyer
This keyer includes sidetone, and has adjustments for
volume, tone frequency, and weighting, as well as speed.
It will key either positive or negative voltages, and
is powered by an internal 9 V battery, or external 5 to
9 volt supply. It is made to go on the back of a Bencher
Paddle.
It works 100%, and looks great also.
With paper work for $45.

Bencher BY-1 Iambic Paddle
True Bencher, and not the MFJ clone. This has the black
base, with chrome parts. It looks great and works the
same. $65

Wall Wart Power Supply
This power supply will furnish 9 Volts DC and has the small
2.5 mm plug on it, as needed by the MFJ-422 above. $10

Buy all three of the above for $110.


Kenwood PC-1 A Phone Patch / Interface:

This phone patch matches most Kenwood rigs, and is the
model with the 8 pin connectors, although they can be
changed, if needed. In addition to being used as a phone
patch, it can be modified to be used as a digital interface.
It includes a nice meter for adjusting the null so VOX
will work OK, and also to set levels.

This particular unit looks like new. I do not find a
scratch on it.  With paperwork for $45.


Operator's Manual for Kenwood (Trio) TS-440 S:

This is a quality reproduction with a "comb" binding
that has been done by one of the professional reproduction
houses. W7FG I think.

This one has a plastic protector on the front, and is
in very nice condition. It includes schematic diagrams.
$18


Original Manuals for Kenwood equipment:

All manuals are in very nice condition, for Kenwood equipment.
All are original manuals only.

Operating manual for TM-2570/2550/2530 2 m xcvr $15
Operating manual for TW-4000 dual bander $15
Service manual for TW-4000 dual bander $20
Operating manual for TW-4100 dual bander $15
Operating manual for TH-21 HT for 2 m $8
Operating manual for TH-225, 2 m HT $12
Operating manual for TM-221/421 mobile $15
Operating manual for TH-241/441/541 mobile FM transceivers
...For 2 m, 440 MHz, & 1200 MHz. $12
Operating manual for TR-2400, 2 m HT $12
Service manual for TR-2600, 2 m HT $12
Operating manual for TR-7400, 2 m xcvr $8

Kenwood TM G-707 operating manual in Spanish:
Spanish version of the Operating Manual
for the TM G-707 dual band transceiver. New $10
All other manuals are English.

LF-30A Low Pass Filter $5
MC-30 & MC-35 hand microphones $5
MC-85 desk microphone $4
PB-1, PB-2, PB-3, & PB-4 battery packs $3
PS-6 power supply $6
SMC-24 speaker mic $4
SMC-25 speaker mic $4
SP-430 speaker $2
SP-820 Speaker $2

These are original Kenwood manuals only.


I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, and many miscellaneous accessories.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400