[Kenwood] TS-930 YG-455C-1 Filter removal jumper?

[Dr. David Kirkby]

On 06/23/11 06:02 PM, Dr. David Kirkby wrote:
> On 06/23/11 02:08 AM, Roger Shultz wrote:
>> I want to remove the above filter from my TS-930 and though I have the
>> instruction sheet for installation where it reads in step 4 to remove the
>> short connector attached to the filter position, it does not elaborate on
>> what that is or if I can fabricate it.
>>
>> The filter was in the radio when I purchased it which is why I don't know
>> how to successfully remove it.
>>
>> Any help is greatly appreciated including a picture of the original
>> configuration.
>>
>> TNX es 73, Roger, NJ2R
>
> Roger,
>
> I'll look in the service manual and see if I can work this out. My *guess* is
> that the small board may have 3 resistors on it.

It appears I was wrong. It was simpler - just a jumper as the user manual says.

Dave