[Kenwood] CONTROL THE VOLUME OF VS-2 ON TS-850S

[Dan Violette]

Appears to be a pot underneath that needs to be adjusted before you install
it.

>From a search:

"I also got the VS-2 voice unit. The voice is the same as the older VS-1 for
the TS-440, and TS-940, but the unit is in a smaller package. It will speak
the frequency in either English or Japanese. There is a volume control pot
on the bottom of the board which should be adjusted PRIOR to screwing down
the VS-2. The output on my unit was very low, until I tweaked it up. Also
there are jumpers on the board to speed up the voice playback... You'll need
to consult the instruction page for the VS-1 for speeds, as there is nothing
mentioned in the instructions for the VS-2."

I was thinking of the DRU-2 which I got and had to add a pot in the line to
adjust.

/Dan KI6X

-----Original Message-----
From: kenwood-bounces at mailman.qth.net
[mailto:kenwood-bounces at mailman.qth.net] On Behalf Of Jim Vaughan
Sent: Saturday, May 29, 2010 12:50 PM
To: Kenwood List
Subject: [Kenwood] CONTROL THE VOLUME OF VS-2 ON TS-850S

I just installed a VS-2 in my TS-850S.  It works great,
but I can't figure out how to control the volume of the VS-2.

The TS-850S manual doesn't mention the volume of the
VS-2 only how to install it.

Can anyone help?

Thanks.

73,
Jim, K4TXJ
______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Kenwood at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html