[Kenwood] TS-870 Shield Plate

[Clif Holland]

Are you referring to the heat sink for IC37-IC38? If so it is referenced in 
the service manual pg 84, location 4G as A1 and in the parts list as PN 
F01-1005-04.

Clif Holland KA5IPF
www.avvid.com




----- Original Message ----- 
From: "Trevor Pitman" <jantree at satlink.com.au>
To: <Kenwood at mailman.qth.net>
Sent: Sunday, November 16, 2008 6:03 PM
Subject: [Kenwood] TS-870 Shield Plate


Hello Group

I recently purchased a 96 model TS-870. When checking the radio eproms
I noticed some solder pads on the TX/RX board. Upon investigation I
find this is where an "L" shaped shield plate is soldered. NOT ON MY
UNIT.
Does anyone know when this part was introduced/dropped? or where I can
purchase same. I believe Kenwood don't have them and this part is not
listed in the service manual copy I have.

Anyone have a DEAD TX/RX board WITH THIS PART FITTED FOR SALE????

Thanks in advance
Trevor
VK3VG



--------------------------------------------------------------------------------


> ______________________________________________________________
> Kenwood mailing list
> Home: http://mailman.qth.net/mailman/listinfo/kenwood
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:Kenwood at mailman.qth.net
>