[Kenwood] Replacement for DAP236K Diode Pack

[Dave Mueller]

About a year ago I acquired a clean TS450 that had a problem with the 
receiver, the wide filter was selected all the time.  I finally traced 
it to the IF board D3/D4 diodes that switch some of the filters in/out.  
This is a DAP236K common anode SMT pair.  I can't find this part or 
figure out what a replacement would be.  The other filters use an RLS135 
single diode on either side.  Since the switching logic all comes from 
the same chip, can I substitute the RLS135, assuming I can get a pair to 
fit on the pcb pads?  I think those are available from RF Parts.

Thanks & 73
Dave AA3EE