[Kenwood] Fix for '940

[solo22 at sbcglobal.net]

This group is always very helpful with troubles I've had in the past.  
These "clues" save hours of troubleshooting and are very welcome.  This 
time, however, I heard from no one.  So maybe I'm the first one in this 
group with this problem.  After lots of circuit tracing this was found.  
On board X41-160, located next to the speaker, under a metal plate, 
which contains various sliding controls, including the Carrier Lever 
control, I found a land had turned loose from a plug pin.  Soldering 
wasn't enough,  jumpers to both pins of that plug were required.  Both 
me and my '940 are smiling again.
Thanks, as always, for the help I've received in the past, 73,  K6ZL