[Kenwood] Wanted info about dsp-100

[John Shafer]

The unit I had opportunity to look at is hard wired (no connector) 120V
only.  No external voltage change switch. The operating voltage isn't listed
in the specifications table in the operating manual, so I doubt there is any
internal provision.

73,

John S W6PTT

-----Original Message-----
From: kenwood-bounces at mailman.qth.net
[mailto:kenwood-bounces at mailman.qth.net] On Behalf Of Allan
Sent: Friday, May 25, 2007 12:49 PM
To: Kenwood at mailman.qth.net
Subject: [Kenwood] Wanted info about dsp-100

Hi all,
I look for on internet but don’t find any answer about this question.
Is it possible easy for changing the voltage of the dsp-100 ( 120 volts to
220/230 volts ) ? 
There is just a switch to turn on some power-supply or a easy system like on
the tl922 ; maybe this is a easy system too ?
I live in Europe and I find one to buy from USA.
Many thanks  for any answer,
Regards
Allan

______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:Kenwood at mailman.qth.net