[Kenwood] Many misc small accessories for Kenwood rigs FS

[Ken Simpson, W8EK]

For Sale:

Misc. small accessory items for Kenwood rigs

Kenwood TU-4 C
Subaudible (PL) encoder for Kenwood TW-4000
This unit provides separate tones for the VHF (2 m) portion 
and the UHF (440 MHz) portion.  It plugs in to the TW-4000 
to provide the tones.  No adjustments are normally needed.
This one is in its original box with paper work, hardware, etc.
$65

Small audio plug - round 4 pin with " Y " shaped pin arrangement
This plug was used on many of the Kenwood rigs in the 1970's 
to feed auxiliary audio (touchtone pads, etc.) into the rig.  It is 
about 1/4 inch in diameter and has the 4 pins arranged so they 
look like a " Y ".  As I recall, this was used on many of the multi
mode rigs (TR-9000, TR-9130, etc.), dual banders (TW-4000, 
TW-4100, etc.), and maybe other rigs like the TR-2200.  I was 
once told that this was "unobtanium", but I found one.  $10

Pack of accessory plugs for HF rigs
This is an original packet of accessory plugs, as found with many 
of the Kenwood HF rigs.  I think this one came from a TS-440, but 
it could have been any number of other HF rigs.  It consists of a 7 
pin DIIN plug, an 8 pin DIN plug, a fuse, a speaker plug, and a 
"Calibrator cable."  This is original Kenwood in the original bag, 
and has never been used.  I don't think it was even opened.  $12

Battery charge cable for Kenwood TR-2400 HT
This is an adapter that permits one to charge the battery of the 
Kenwood TR-2400, 2 meter HT, outside of the HT itself. Usually, 
one must have the battery inside the HT, but this lets you charge 
a second battery outside of the HT. The original charger is used. 
It is in good shape, and works fine.  $3

Kenwood PB-21 battery pack for TH-21 / 31 / 41 series HTs
This battery pack does not hold a charge well.  Physically it is fine, 
but it needs a new "insert" in it.  $15  

Wrist strap for TH-21 / 31 / 41 and likely other HTs $ 2

Antenna adapter for Kenwood TH-21 / 31 / 41 HTs
This adapts the antenna connector found on these HTs to a standard 
BNC connector.  $3

Special Rubber Duck antennas for Kenwood TH-21 series 
HTs with the threaded connector
Aftermarket stubby, 3.3 inches long $10
Kenwood RA-8 Stubby, 4 inches long $12
Kenwood regular, 6.6 inches long $10

440 MHz stubby rubber duck antenna with BNC connector
This stubby 3 inch long antenna can be used on any of the 440 MHz
HTs that use a BNC connector.  $10

Antenna adapter to fit the BNC connector on the HT and provide 
an SO-239 connector that will permit a PL-259 to be attached. $5

Kenwood EP-1 ear phone
Used on many Kenwood HTs. Like new. $4

Service manual for Kenwood TR-2600 HT - $10

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone (352) 732-8400