[Kenwood] TM241A Extended Receive Question

[K8CM]

I have no idea of what buttons you may have pressed or in what 
order.  Though, as I recall, that radio (I had three) enjoyed a few 
undocumented features.

I assume you (or a previous owner) have performed a modification to extend 
the frequency range.  With this in mind, you may be looking at a hard reset 
to restore the wide-band capability.

If this doesn't solve the problem, you might look closely at the band 
diodes in the event one failed or is the victim of a cold-solder joint.

Good luck.

73  <>  Carl

At 02:42 PM 9/14/2005, you wrote:
>I have a TM241A that I have been using for quite a while. Up until this 
>past weekend, the receiver would receive from 118Mhz through 174Mhz. Now 
>the receiver will tune from 118Mhz to 147.995Mhz, then starts at 118 again.
>
>Anyone in the assembled brain trust have any clues to what combination of 
>buttons I may have pressed to change this feature, and any ideas on how to 
>change it back to full extended receive?
>
>Thanks for your help.
>
>73
>Bruce
>WA3RHW
>
>______________________________________________________________
>Kenwood mailing list
>Home: http://mailman.qth.net/mailman/listinfo/kenwood
>Help: http://mailman.qth.net/mmfaq.html
>Post: mailto:Kenwood at mailman.qth.net