[Kenwood] KENWOOD AT-200

[Walt Breining]

I am not sure what these shafts are, but if they are straight shafts, you
might look into the stems from olde mobile CB antennas. They are made of
various materials. Remove the jacket, unwind the wire, and sand the shaft.
Usually can be had for free around truck stops and CB shops. The defect is
that the wire breaks at the bottom.

Vie 73, Walt N9WB
Always Scrounge'n

----- Original Message ----- 
From: "Ray" <atp1986 at mchsi.com>
To: <kenwood at mailman.qth.net>
Sent: Thursday, October 20, 2005 10:36 AM
Subject: [Kenwood] KENWOOD AT-200


> Hello Group, I have a Kenwood AT-200 that was
> damaged in shipment. Does anyone out there
> have a trashed AT-200 for parts. In need of the
> plastic/nylon shafts or shaft assemblies for the
> RX and TX tune controls the knobs fasten
> too...East coast is out of stock...Not available
> from Kenwoody...
>
> 73
> Ray, N6XVO