[Kenwood] Kenwood TM-V7A Crossband info needed

[Tim KD5CKP]

-------- Original Message --------
Subject: 	RE: [Kenwood] TM-V7A Cross-Band Repeat
Date: 	Fri, 25 Feb 2005 10:50:03 -0800
From: 	KCC-Amateur <kcc-amateur at kenwoodusa.com>
To: 	<kd5ckp at likespecies.com>



Dear Kenwood Customer:

Thank you for your e-mail and your support in Kenwood Products.  

Below is the instructions on how to put the TM-V7A in cross-band repeat.

1. Turn Off Microphone control (Press Menu and Select 16.1)
2. If you are the PM Mode, Press PM then Press VFO to get out of this
mode.
3. Select VHF frequency (example 146.670 - PL with Tone 131.8). Now
select 
   UHF frequnecy (example 446.000 simplex) UHF the TX main band. 
4. Now program your handheld to (example 446.000 simplex), UHF now the
TX main band. 
5. Press Cont Select Button (Cont Select is located between the two
volume controls) 
   the display above the VHF band will show ctrl. 
6. Turn Radio Off
7. Press and Hold the Left Volume Control while you turn the radio on.
Now above the 
   UHF band "PTT" will be blinking, and now Cross Band Repeat is
activated. 
8. To Exit Cross-Band Repeat Mode, repeat step 7  

If you need further assistance, please e-mail us again.

Sincerely,
Kenwood Amateur Radio Customer Support

-----Original Message-----
From: kenwood-bounces at mailman.qth.net
[mailto:kenwood-bounces at mailman.qth.net] On Behalf Of Tim KD5CKP
Sent: Friday, February 25, 2005 9:57 AM
To: Kenwood at qth
Subject: Re: [Kenwood] TM-V7A Cross-Band Repeat

maybe someone knows the secret. I have tried and tried and it does
nothing, but PTT sits there and blinks it's little heart out.


kc7hkP at comcast.net wrote:

> i tryed to get mine to also and could not
>  
> --
> KC7HKP
> George Yazzolino
> 14801 NE 20th Circle
> Vancouver, Wa. 98684
> Grid CN-85
>  
>
>     -------------- Original message --------------
>
>     > OK maybe I am not the sharpest tool in the shed, but this does
>     not seem
>     > like it should be difficult.
>     >
>     > The instructions say
>     >
>     > 1. Press the right or left {BAND SEL}
>     > 2. Press {CONT SEL}
>     > 3. Press the left {BAND SEL}+ POWER ON
>     >
>     > "PTT" does begin to blink but nothing happens when a signal is
>     received.
>     >
>     > Any ideas folks??
>     >
>     >
>     > Tim KD5CKP
>     > http://www.dixiefest.org
>     >
>     > ______________________________________________________________
>     > Kenwood mailing list
>     > Home: http://mailman.qth.net/mailman/listinfo/kenwood
>     > Help: http://mailman.qth.net/mmfaq.html
>     > Post: mailto:Kenwood at mailman.qth.net 
>



______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:Kenwood at mailman.qth.net