[Kenwood] KW 930. NO AM output

[Clif Holland]

Digging back thru the notes......

1. Do you have a service manual? Not necessary but easier to locate parts 
with it.

2. If so locate J67. This is a wire jumper on the left side of the signal 
unit next to L90. If there is a diode in the unmarked holes paralleling J67 
to the rear of the radio, cut it. It inhibits TX in AM but affects nothing 
else. I have seen it in several US radio for whatever reason.

Clif Holland, KA5IPF
www.avvid.com


----- Original Message ----- 
From: "Tom" <ka9vaa at fibernetcc.com>
To: <kenwood at mailman.qth.net>
Sent: Tuesday, September 07, 2004 8:50 AM
Subject: [Kenwood] KW 930. NO AM output


>I have a 930sat that has full (100watts) output in usb,lsb.cw,amd fsk but 
>zero when switched to am. The receive works fine in all modes. Antenna 
>tuner works fine.
>
> Anyone have any ideas where or what to look for?
>
> Thank you for any help.
>
> ka9vaa
> _______________________________________________
> Kenwood mailing list
> Kenwood at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/kenwood
> Help: http://mailman.qth.net/subscribers.htm
>