[Kenwood] Dg-5 Not working. Help needed

[Jim Ricker]

Hello just got through re arranging the shack. As I leaned over the TS520s
to connect the DG-5 II accidentally powered everything off. hit the power
switch. I did this at the same time I was plugging in the power cord from
the DG-5. I heard a slight click/pop. I then noticed that the rig was on. I
shut everything down.  I then I turned it back on the radio was ok but no
display from the DG5. I then did the following.

 

1.	I replaced the 2AMP fuse on the back off the radio. 
2.	Fired up the radio still nothing from the DG-5
3.	Shut it down and checked the 2 Amp fuse it was blown.
4.	 Again I replaced the 2AMP fuse on the back off the radio.
5.	Fired it up still nothing from the DG5. 
6.	Shut it down and found that again the 2 Amp fuse was blown.
7.	I replaced the 2 amp fuse and removed the power cord from the DG-5 .
8.	Fired up the rig and let it run for 30 minutes.
9.	Shut off the rig and checked the 2 amp fuse it was fine. 
10.	Let everything sit for 24 hours. Plugged back in the DG05 Powered on
the radio.
11.	Nothing from the DG-5, Shut it down and checked the fuse it was
blown

 

 The radio is working great. The Dg-5 was working fine prior to this
incident.

 

Any ideas??   Thanks Jim