[Kenwood] TS-930S: Service Manual Voltage Adjustments

[Linden, Mike (BRC-Hes)]

  I had some problems when I went through the Voltage Adjustment section of
the TS-930S Service Manual. I believe there are some errors in the
procedures. Is anyone familiar with these checks/adjustments?

  Item 1. Voltage, of the Voltage Adjustment section on page 64 says that
jumper J13 should be at 2.20V. I found J13 to be around 16V on a normally
operating radio. However, J12 was at 2.20V. Should this item reference J12
instead of J13?

  Item 2. TX Control Voltage, of the Voltage Adjustment section on page 64
says that jumper J89 should be at 3.20V on transmit. I found J89 to be
around 16V on transmit on a normally operating radio. Again, it looks like
they've referenced the incorrect jumper.

  Are these errors or am I missing something?

  Thanks, Michael N9BDF


PS  The "Amateur Radio Emergency Communications Consistency Act" (HR 1478)
and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are in
Congress. Please contact your Congressmen to ask for their support of these
bills! See the following ARRL link for details:
http://www.arrl.org/govrelations/