[Kenwood] Mic Schematic needed

Tue, 9 Sep 2003 10:26:18 -0400

Hello Michael....
    I had a similar problem with my 241 microphone. I found that by pushing
the back of the case, near the lock switch, and while pushing the PTT, the
mic would work. Sensing a bad connection inside, I opened the case and by
probing the wires at the bottom of the circuit board (on the backside),
found a bad solder connection on one of the wires. It was re-soldered and
the problem was solved.
    Hope this helps.
BTW....I don't know of a schematic for the microphone.
Darrell,
    VA3DG/VE3DDG

Michael, N0XY wrote.....
> I have a TM241A 2 meter rig and the stock mic has an intermittent problem.
> It would seem to be intermittent power wire or ground wire, as all
> functions cease when it craps out. I have not been able to isolate
> anything. It has always started working before I got too far with it.
>
> I sure could use a schematic of this mic's circuitry.
>
> Can anyone help out?
>
> 73
> Michael
> N�XY
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood