[Kenwood] at-250 help needed

Mon, 27 Oct 2003 08:57:16 +0100

Isaac,

I had a similar problem in my 940 some time ago. The reason was a loose
mechanical coupling between the motor and tuning cap.
Check the mechanics first, before you dig too deep!

Svein, LA3BO

-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of Tsachy L
Sent: 24. oktober 2003 16:08
To: [email protected]
Subject: [Kenwood] at-250 help needed

Hello
My at-250 is unable to tune 4  "good otherwise" dipoles.
It just will not find a match.
Motors work, band control from rig is ok, antennas are ok (1.5 SWR regular).
Can anyone point me to the schema and / or troubleshooting  guide ?
Any ideas?
Thanks in advance, Isaac, 4Z4TL

       http://www.iarc.org/~4z4tl/
[email protected]  [email protected]

- - -

Your moderator for this list is:
Larry Wilson KE1HZ [email protected]

_______________________________________________
Kenwood mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/kenwood