[Kenwood] MC-60

Wed, 22 Oct 2003 14:03:05 -0700

Bert,

To open the microphone, heat at the junction between the two parts with
a hot air gun or hair dryer.  This softens the glue that holds it
together and you will be able to unscrew the two sections.  It takes a
bit of heat to accomplish this, so be sure to use a towel or something
to hold the mike.

There is a PDF copy of the manual on my website @ 
http://ww6j.com/images/MC-60A_Instruction_manual.pdf

73 

Jeff WW6J

www.ww6j.com

 This e-mail is for the use of the intended recipient(s) only. If you
have received this e-mail in error, please notify the sender immediately
and then delete it. If you are not the intended recipient, you must not
use, disclose or distribute this e-mail without the author's prior
permission. We have taken precautions to minimize the risk of
transmitting software viruses, but we advise you to carry out your own
virus checks on any attachment to this message. We cannot accept
liability for any loss or damage caused by software viruses.

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Bert Prijt
Sent: Wednesday, October 22, 2003 1:16 PM
To: [email protected]
Subject: [Kenwood] MC-60

I'm looking for a drawing of the mic. amp. from the MC-60.
Can any one tell me how I can get the microphone from the MC-60 open.

thanks PA1TRS

[email protected]

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
- - -

Your moderator for this list is:
Larry Wilson KE1HZ [email protected]

_______________________________________________
Kenwood mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/kenwood