[Kenwood] 850 Noise Blanker ??

Mon, 10 Nov 2003 01:32:13 -0500

    I actually am curious about this too, on my TS-940.  Sadly, there is
interference coming from somewhere new that it hasn't before.  I've seen
It's about an S-5 on the meter, and kicking either NB in will get rid of it
in the same way.  The level control does not seem to have very much effect
on what happens (if any).

    I'm curious if the electrical system of my apartment building is all
tied together at some point past the meters.    I'm guessing that it is,
since I've had bad flickering on my computer monitor with the refresh turned
up high, when someone flips a microwave on.  I'm wondering what type of junk
that someone may have plugged in, that would cause this S-5 noise, which can
be described as a "buzzing static."

73,
Chris, N9WIV
----- Original Message ----- 
From: "Bob Snelgrove" <[email protected]>
To: <[email protected]>
Cc: <[email protected]>
Sent: Monday, November 10, 2003 12:53 AM
Subject: [Kenwood] 850 Noise Blanker ??


> Hi Gang
>
> I don't know if my NB is working like it should. Both NB1 and 2 work
> exactly the same when the bedroom light dimmers are on, cuts the noise
from
> s9 down to s3 and I can copy the signal.  BUT, when either is on, the NB
> level or width (nb2) do absolutely nothing.  It's like NB 1 and 2 are
> either on or off with no parameter control and the both react exactly the
> same??
>
> thx
>
> bob
>
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood
>