[Kenwood] TS-2000

[Greg Taylor]

I just got my new TS-2000 yesterday. After hooking everything up, everything
seemed to work great on receive on all bands. In order to make sure
everything was ok I decided to try transmitting into my 50 ohm dummy load.
VHF and UHF seem to work ok but my problem is on HF and 50 MHz. The rig keys
ok but there is no power out. I tried both antenna 1 and 2 with no success.
I have tried every mode and every HF band but to no success. I noticed that
with an antenna to only ant1 or ant2 I could switch between these and
noticed no difference in receive. The one without the antenna received as
well as the other. I am new to this rig but I have a TS-870 and used the
same dummy load and antenna system I use with it. I may have something set
wrong. Any ideas or suggestions?

73

N9OUK Greg

n9ouk@arrl.net
http://my.hsonline.net/~gtaylor/index-2.htm

"The only thing necessary for the triumph of evil is for good men to do
nothing."
Edmund Burke (1729-1797)