[Kenwood] Re: TS-570 Question

Wed, 30 Jul 2003 11:51:11 -0400

Hi Dave,

I have a TS-570SG about 2 years old and it seems to rx in CW all the way to
30 kHz. Note that when I checked it this morning, there were no signals
heard just band noise. Is yours an early version? I seem to recall that some
of the earlier (non-G) versions had firmware restrictions of that sort.

Best regards, Eric W1EL
----- Original Message ----- 
From: "Dave Holford" <[email protected]>
To: <[email protected]>
Sent: Tuesday, July 29, 2003 7:45 PM
Subject: [Kenwood] Re: TS-570 Question

>
> I have noticed that my TS-570 does not operate in CW receive
> below 500kHz. All other modes work just fine right down to 30kHz,
> but CW cuts out/in as I tune across 500kHz.
>
> I cannot remember if I ever tried this before so am not sure if it has
> always been this way. Cannot find any mention in the manual, or
> the menus.
>
> Can anyone advise me if this is normal, or if I have a problem with
> my unit?
>
> Thanks
> Dave Holford
> VE3HLU
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood