[Kenwood] (no subject)

Wed, 15 Jan 2003 11:10:26 -0500

The 220's manual describes how to align and use it for a bandscope. It's 
rather involved. I assume you have the BP8 installed inside the scope? It 
doesn't show from the outside so you would need to pop off the cover to 
find out. It should work ok with the TS-940 but not the 930. 

N4LQ

-----Original Message-----
From: "RROSENTHALL" <[email protected]>
To: [email protected]
Date: Wed, 15 Jan 2003 10:18:16 -0500
Subject: [Kenwood] (no subject)

> Hi Guys.----- I just got an SM 220 with pan adaptor to go with my TS
> 940S/AT. So far I haven't used it because I still have to make up a
> cable with a BNC connector at one end. However, I've been following
> the exchango of info. that's been going on and I find it very
> interesting. Is there anything special that I have to know when
> operating it in the bandscope mode ??
> 
> Tnx.  Richard VE3MG
> 
> - - -
> 
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
> 
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood
> 